Superior DRL4072 See Through Gas Fireplace
Black Friday Sale
Contact us for this item's sale price. Our team quotes it by phone, text or chat.
Ends Nov 27 · Some exclusions apply
Black Friday Sale
Contact us for this item's sale price. Our team quotes it by phone, text or chat.
Ends Nov 27 · Some exclusions apply
The Superior DRL4072 See Through is a 72" linear gas fireplace you can watch from two rooms. It pairs the DRL4072TEN fireplace with Superior's see-through conversion kit, so a long, low fire over reflective black crushed glass shows on both sides of the wall.
It's a direct vent fireplace, so it pulls combustion air from outside and vents through the top, which leaves the room air alone. The kit arrives with the fireplace, ready for your installer to convert.
Each side has a ceramic glass viewing area 68-5/8" W x 15-5/8" H, with a protective screen barrier. On natural gas it runs from 45,000 down to 31,500 Btu/hr, and the electronic IPI/CPI ignition has a four AA battery backup, so the burner still lights in a power outage.
A see-through fireplace works well in a wall between a living room and a dining room, a kitchen and a family room, or a primary bedroom and its sitting area. Browse our other see-through and multi-sided fireplaces, or see every size in the Superior DRL linear gas fireplaces lineup.
Superior ships the DRL4072TEN as a one-sided fireplace, and the see-through kit (STK-LIN72) converts it on site. Frame for the see-through depth from the start: the opening is 86-1/4" W x 48-1/2" H x 18-1/2" D, 1" shallower than a one-sided install. It vents through the top with 6" x 9" Superior 6DVL (DV Lock). The HeatFlo kit works with the see-through setup if a TV or artwork is going on the wall above.
Want only one face? The Superior DRL4072 72" Linear Contemporary Direct Vent Gas Fireplace is the same fireplace without the kit.
Fireplace (DRL4072TEN):
See-through kit (STK-LIN72):
Required: Control (choose one)
A wall switch or thermostat works too, using the wire that ships with the fireplace.
Required: Venting (6" x 9" 6DVL, ordered separately)
Optional: HeatFlo and trim
Optional: Media and logs
Optional: Gas conversion and touch-up
Superior's glass liner kits and add-on blower kits don't work with a see-through setup, so they aren't offered here.
| Model | DRL4072TEN fireplace with STK-LIN72 see-through kit (natural gas; propane with conversion kit) |
| Superior item numbers | F4390 (fireplace), F4411 (see-through kit) |
| Type | Linear direct vent gas fireplace, see-through, sealed combustion |
| Input, natural gas | 45,000 Btu/hr high, 31,500 Btu/hr low |
| Input, propane (conversion kit) | 43,000 Btu/hr high, 32,250 Btu/hr low |
| Efficiency, natural gas | 55.0% AFUE, 57.0% P4 |
| Efficiency, propane | 55.0% AFUE, 57.8% P4 |
| Glass viewing area | 68-5/8" W x 15-5/8" H, each side |
| Fireplace size | 86" W x 48-1/4" H x 20-1/8" D |
| See-through framed opening | 86-1/4" W x 48-1/2" H x 18-1/2" D |
| Minimum base to ceiling | 84" |
| Ignition | Electronic IPI/CPI with four AA battery backup |
| Power | 120 VAC, 60 Hz, unswitched, grounded, to the junction box on the left side |
| Gas inlet pressure | Natural gas 5" to 10.5" WC; propane 11" to 13" WC |
| Venting | Direct vent, top, 6" x 9" Superior 6DVL (DV Lock) |
| Vent run | Up to 40 ft vertical, starting with at least 2 ft of vertical vent off the fireplace; horizontal run per the vent chart in the manual |
| Media and interior | Reflective black crushed glass (four 5 lb bags); black painted interior |
| Altitude | 0 to 4,500 ft with the standard orifices |
| Listing | ANSI Z21.88 / CSA 2.33 and CSA 2.17, vented gas fireplace heater (PFS report F11-26) |
| Approved locations | Bedrooms; aftermarket mobile homes and permanently located manufactured homes (USA only) |
| Shipping weight | Fireplace 560 lb; see-through kit 175 lb |
| Warranty | 20 year limited (see Warranty below) |
Efficiency figures are from Superior's see-through smart sheet; the propane figures are with the conversion kit installed. Clearances, mantel heights and the full framing drawings are in the installation manual.
Both faces have tile stops, from the fireplace and the see-through kit, so tile, stone or another non-combustible facing can run right up to the glass. Add the black linear trim kit for a framed look, and change the media with reflective blue or platinum glass, river rock or the driftwood log set. Compare it with the other linear gas fireplaces we carry.
The DRL4072 See Through suits a new build or a remodel where one fire should anchor two spaces. Reach out to our team for help planning the framing, the vent run or the finish on each side.
How does it ship?
As two boxes: the DRL4072TEN fireplace, which leaves the factory as a one-sided unit, and the see-through kit. Your installer converts it on site following the instructions that come with the kit.
Can I add a blower or a glass liner?
No. Superior's add-on blower kit and its reflective glass liner kits aren't compatible with the see-through kit. The HeatFlo kit, the trim kit and the media and log options all work with it.
Is it available for propane?
It ships for natural gas. Superior's GCK-M-4072NP conversion kit changes it to propane, at 43,000 Btu/hr high and 32,250 Btu/hr low.
How do I frame for it?
The see-through framed opening is 86-1/4" W x 48-1/2" H x 18-1/2" D, and you need at least 84" from the base of the fireplace to the ceiling. Both faces get non-combustible fireboard, which ships with the fireplace and the kit.
Can I put a TV above it?
Yes, with the spacing in Superior's installation manual, and the TV must stay within its maker's temperature rating. The HeatFlo kit sends warm air out a register near the ceiling instead of up the wall. Our guide to fireplace heat management explains how these kits work.
Superior's 20 Year Limited Warranty covers the DRL4072 against defects in materials and workmanship:
Vent components, trim and paint are not covered. The warranty is for the original owner of a fireplace installed in the US. Full terms are in the warranty certificate.