Empire 16"/18"/24"/30" Vent-Free Slope Glaze Gas Burner, Variable Flame Remote
The Empire 16"/18"/24"/30" slope glaze burner with variable flame remote control (model numbers VFSV16NAT, VFSV16LP, VFSV18NAT, VFSV18LP, VFSV24NAT, VFSV24LP, VFSV30NAT and VFSV30LP; NAT for natural gas, LP for propane) is a vent-free gas log burner for a wood-burning fireplace or a listed vent-free firebox. A matching Empire refractory or Burncrete log set is required and ordered separately.
A variable flame valve and an included handheld remote let you turn it on and off and set the flame height from your seat. It can also be installed as a vented decorative appliance with the damper clamped open.
Key Features
- Slope glaze burner for vent-free Empire log sets
- 16", 18", 24" and 30" sizes, up to 38,000 Btu/hr
- Variable flame with included handheld remote
- Standing pilot
- Rock wool embers and lava rock included
- Vent-free, or vented with the damper clamped open
What to Order With It
The burner ships with rock wool embers, lava rock, the remote kit and anchor screws. The 16" burner needs a 16" Empire log set; none is stocked on our site, so ask us before ordering the 16".
Log sets for the 18" burner (one required, ordered separately):
Log sets for the 24" burner (one required, ordered separately):
Log sets for the 30" burner (one required, ordered separately):
Optional – Embers, grate, risers, hood and gas line:
-
Ember Bed Kit, traditional (EK1)
-
Platinum Glowing Embers (PE20)
-
Fireplace Hood, Black, adjustable (lowers the mantel clearance) (ELH1)
-
Decorative Grate, Black, 24" (DCG24BL)
-
Flex Gas Line, 24", Stainless Steel (GF24)
-
Log Riser, 2", for the 18" burner (LR18)
-
Log Riser, 2", for the 24" burner (LR24)
-
Log Riser, 2", for the 30" burner (LR30)
Specifications
| Model numbers |
VFSV16NAT, VFSV16LP, VFSV18NAT, VFSV18LP, VFSV24NAT, VFSV24LP, VFSV30NAT, VFSV30LP |
| Sizes |
16", 18", 24", 30" burners |
| Type |
Unvented (vent-free) gas log heater, also certified as a vented decorative appliance |
| Input, maximum / minimum |
16": 25,000 / 18,000 natural gas, 22,500 / 17,000 propane; 18": 32,000 / 21,000; 24": 36,000 / 24,000; 30": 38,000 / 27,000 Btu/hr (18" to 30": natural gas and propane) |
| Control |
Standing pilot with variable flame valve; handheld remote (on/off and high/medium/low) included; remote runs on two AA batteries |
| Safety |
Oxygen depletion sensor (pilot safety system) shuts the burner off if fresh air runs low |
| Fuel |
Natural gas or propane; field conversion not permitted |
| Minimum firebox |
16": 24" front width, 18" rear width, 11 1/2" deep, 18" high; 18": 28" front width, 17" rear width, 14" deep, 17" high; 24": 30" front width, 23" rear width, 14" deep, 18" high; 30": 34" front width, 26" rear width, 14" deep, 20" high |
| Log set |
Required, ordered separately; use only Empire logs made for this burner |
| Manufactured homes |
May be installed in an aftermarket manufactured (mobile) home where local codes allow |
| High altitude |
Above 2,000 ft, the manual says ratings are reduced 4% for each 1,000 ft above sea level; contact Empire |
Installation Requirements
-
Where it can go: in a solid-fuel-burning masonry or UL 127 factory-built fireplace, or a listed vent-free firebox; not in a factory-built fireplace whose instructions say it should not be used with unvented gas logs. Have the chimney and firebox cleaned first, and seal any fresh-air vents or ash doors in the firebox.
-
Firebox size: the fireplace or firebox opening must be at least 16": 24" front width, 18" rear width, 11 1/2" deep, 18" high; 18": 28" front width, 17" rear width, 14" deep, 17" high; 24": 30" front width, 23" rear width, 14" deep, 18" high; 30": 34" front width, 26" rear width, 14" deep, 20" high. With glass doors, use the door frame opening as the front width; the doors must be fully open whenever the logs burn.
-
Room size: the room must be an unconfined space of at least 50 cubic feet per 1,000 Btu/hr of input of all gas appliances drawing air from it, or extra combustion and ventilation air must be provided as the National Fuel Gas Code describes. Vent-free heaters are for supplemental heat, not as a primary heat source.
-
Bedrooms and bathrooms: an unvented heater over 10,000 Btu/hr may not go in a bedroom or bathroom, so this burner cannot. Massachusetts prohibits unvented gas heaters in bedrooms and bathrooms.
-
Clearances: the sides of the fireplace opening at least 6" from any combustible wall; a ceiling at least 36" above the opening for the 16" burner and 41" for the 18", 24" and 30".
-
Mantel: non-combustible material must extend at least 12" above the opening, or 8" with the optional ELH1 hood. A combustible mantel must meet the mantel chart in the installation manual.
-
Vented use: the VFSV burner can be installed as a vented decorative appliance with the damper clamped open, using the damper clamp.
-
Media: rock wool (glowing embers) goes on the front of the burner, never over the large burner ports; lava rock goes on the firebox floor only, never on the burner or logs. Use only Empire logs made for this burner, placed as the log set manual shows.
-
Fuel: order the model for your gas; field conversion is not permitted.
-
Installation: must be installed by a qualified installer per the installation manual and local codes, with the burner anchored to the firebox floor. In Massachusetts the installation must be done by a licensed plumber or gas fitter.
Downloads
Warranty
Empire limited warranty, from the warranty section of the installation manual:
- All components, except remote controls, thermostats, accessories and replacement parts: 5 years parts and labor
- Remote controls, thermostats, accessories and parts: 1 year parts
The warranty applies to the original purchaser. Full terms, including what is not covered, are in the warranty section of the installation manual.
