Superior VRL6048 See Through Vent-Free Gas Fireplace
Black Friday Sale
Contact us for this item's sale price. Our team quotes it by phone, text or chat.
Ends Nov 27 · Some exclusions apply
Black Friday Sale
Contact us for this item's sale price. Our team quotes it by phone, text or chat.
Ends Nov 27 · Some exclusions apply
The Superior VRL6048 See Through is a 48" linear vent-free gas fireplace you can watch from two sides. It pairs the VRL6048 fireplace, with its floor lighting, black porcelain liner and multi-function remote, with Superior's see-through conversion kit, and it needs no chimney or vent pipe.
Choose the indoor see-through kit to share the fire between two rooms, or the indoor/outdoor kit to put the second face outdoors, on a patio or porch. Both come with the fireplace, ready for your installer to convert. Order it for natural gas or propane: it can't be changed from one gas to the other later.
Each side shows a 46" W x 14-1/2" H viewing opening. With the indoor kit the second face gets its own screen barrier, and the indoor/outdoor kit closes the outdoor face with glass. On natural gas it runs from 35,000 down to 28,000 Btu/hr (propane 34,000 to 27,000), and the electronic IPI/CPI ignition has a four AA battery backup, so the burner still lights in a power outage.
Because it's vent-free, it burns room air and keeps its heat in the room, with an oxygen depletion sensor on the pilot that shuts it off if the air runs low. The room has to be large enough or ventilated (see Installation Requirements), and it can't be installed in a bedroom or bathroom. Browse our other see-through and multi-sided fireplaces, or compare it with our vent-free fireplaces.
Superior ships the VRL6048 as a one-sided fireplace, and the see-through kit (STK-VFLIN48 or OSTK-LIN48) converts it on site. Frame for the see-through depth from the start: the opening is 55-5/8" W x 39-1/8" H x 18-1/2" D, 1" shallower than a one-sided install. The factory blower can't run in a see-through setup, so it's removed or disabled during the conversion, and Superior's reflective glass liner kit isn't compatible with either kit. The HeatFlo kit works with the see-through setup if a TV or artwork is going on the wall above.
Want only one face? The Superior VRL6048 48" Linear Contemporary Vent-Free Gas Fireplace With Electronic Ignition is the same fireplace without the kit.
Fireplace (VRL6048ZEN or VRL6048ZEP):
See-through kit, the one you choose:
Nothing else is required: the remote comes with the fireplace, and a vent-free fireplace needs no vent pipe.
Optional: HeatFlo and trim
Optional: Media
Optional: Touch-up paint
Superior's reflective glass liner kit doesn't work with a see-through setup, so it isn't offered here.
| Models | VRL6048ZEN (natural gas) or VRL6048ZEP (propane) fireplace with the STK-VFLIN48 or OSTK-LIN48 see-through kit |
| Superior item numbers | F4858 / F4859 (fireplace), F4854 / F4869 (see-through kit) |
| Type | Linear vent-free gas fireplace (unvented room heater), see-through (indoor/indoor or indoor/outdoor) |
| Input, natural gas | 35,000 Btu/hr high, 28,000 Btu/hr low |
| Input, propane | 34,000 Btu/hr high, 27,000 Btu/hr low |
| Fuel conversion | Not convertible; order the natural gas or propane model |
| Efficiency | 99.9% (Superior's rating for this vent-free series) |
| Viewing opening | 46" W x 14-1/2" H, each side |
| Fireplace size | 54-1/4" W x 32-7/8" H x 20" D (39" H to the top of the standoffs) |
| See-through framed opening | 55-5/8" W x 39-1/8" H x 18-1/2" D |
| Minimum base to ceiling | 84" |
| Ignition | Electronic IPI/CPI with ODS pilot; four AA battery backup |
| Blower | Factory-installed; removed or disabled for see-through use |
| Lighting | Floor lighting, six brightness levels |
| Remote | Multi-function: on/off, thermostat, flame height and lights |
| Power | 120 VAC, 60 Hz, unswitched, to the junction box on the left side |
| Gas inlet pressure | Natural gas 5" to 10.5" WC; propane 11" to 13" WC |
| Venting | None (vent-free); the room must supply enough combustion air |
| Media | Platinum crushed glass, two 5 lb bags included; 8 lb maximum in the fireplace |
| Altitude | 0 to 4,500 ft |
| Listing | ANSI Z21.11.2, unvented gas-fired room heater (PFS report F22-809) |
| Approved locations | Not bedrooms or bathrooms; aftermarket, permanently located manufactured homes (USA only) |
| Shipping weight | Fireplace 275 lb; the see-through kit ships in its own box |
| Warranty | 20 year limited (see Warranty below) |
Clearances, mantel heights and the full framing drawings, including the HeatFlo and TV framing for a see-through installation, are in the installation manual.
The VRL6048 See Through suits a remodel or new build where one fire should warm two spaces and running a vent isn't practical. Reach out to our team for help checking your room size or planning the framing on each side.
How does it ship?
As two boxes: the VRL6048 fireplace, which leaves the factory as a one-sided unit, and the see-through kit. Your installer converts it on site following the instructions that come with the kit.
Can I use the blower with the see-through kit?
No. Superior says blowers must be removed or disabled when a see-through kit goes in. The floor lighting and the multi-function remote still work.
What's the difference between the two kits?
The indoor see-through kit (STK-VFLIN48) puts a second face, with its own screen barrier, in another room. The indoor/outdoor kit (OSTK-LIN48) makes the second face an outdoor one, with an outer bezel and glass doors.
Can I switch between natural gas and propane later?
No. The VRL6048 isn't convertible, so choose natural gas (VRL6048ZEN) or propane (VRL6048ZEP) when you order.
How big does the room need to be?
At least 1,750 cubic feet for this fireplace alone on natural gas, counting adjoining rooms without doors, or less with ventilation openings sized per the manual and NFPA 54.
How do I frame for it?
The see-through framed opening is 55-5/8" W x 39-1/8" H x 18-1/2" D, and you need at least 84" from the base of the fireplace to the ceiling. Both faces get non-combustible fireboard, which ships with the fireplace and the kit.
Can I put a TV above it?
Yes, with the HeatFlo kit and the spacing in Superior's installation manual, which covers see-through installations. The TV must stay within its maker's temperature rating. Our guide to fireplace heat management explains how these kits work.
Superior's 20 Year Limited Warranty covers the VRL6048 against defects in materials and workmanship:
Trim and paint are not covered. The warranty is for the original owner of a fireplace installed in the US. Full terms are in the warranty certificate.