Modern Flames Thermostat & Full Wall Control - TH-WTC/LP
The Modern Flames Thermostat & Full Wall Control is an optional wall-mounted touch control for Landscape Pro series electric fireplaces. It puts the fireplace controls on the wall: power, heat, thermostat, timer, flame speed, and the color and brightness of the flame, ember bed and downlight.
It can run wirelessly on two AAA batteries, or be wired to the fireplace with the included 13 ft low-voltage (12V DC) harness. Either way, it pairs with the fireplace the same way the handheld remote does.
Features
-
Power: turns the fireplace on and off; the fireplace returns to its last settings.
-
Heat: cycles the heater between low, high and off.
-
Thermostat: up and down arrows set the temperature, in Fahrenheit or Celsius. The thermostat sensor is in the fireplace, not in the wall control.
-
Timer: 30 minutes, 1, 2, 3 or 4 hours.
-
Flame, Ember Bed and Downlight: select a zone, then use the color slider and the brightness slider to adjust it.
-
Flame Speed: four speeds.
-
Demo Modes: cycles all zones through color fade and color jump modes.
-
Digital Readout: shows the heat, thermostat and timer settings, and fades out when not in use.
What's in the Box
- Wall touch control (glass face, held to the bracket by magnets)
- Metal wall mounting bracket
- 2 AAA batteries
- 12V DC harness, 13 ft, for the optional wired installation
- Mounting screws
- Instruction guide
Installation Notes
- Mount within 20 ft of the fireplace; the same room is recommended for best performance.
- Mounts in a 2-gang low-voltage box (not included) or in a cutout in furniture.
- For a wired installation, run the cable before the wall is finished. Do not install batteries when the control is wired.
Compatibility
For Modern Flames Landscape Pro series electric fireplaces. The Modern Flames installation guide for this wall control is written for the Landscape Pro V2 Series and lists the control as part number MF-PRO-V2-WTC.
Documents
