Skip to content
Free Shipping over $299 | Contact Us for Deals
Free Shipping over $299 | Contact Us for Deals

Empire 18"/24"/30" Vista Multi-Sided Slope Glaze Gas Burner, IP

SKU VFSUE18P
Empire authorized dealer
Original price $1,799.00 - Original price $2,019.00
Original price
$1,799.00
$1,799.00 - $2,019.00
Current price $1,799.00

Free Shipping over $299


Please contact us directly to request quote for Empire products. 

Empire 18"/24"/30" Vista Multi-Sided Slope Glaze Gas Burner, IP

The Empire Vista multi-sided slope glaze burner (model numbers VFSUE18N, VFSUE18P, VFSUE24N, VFSUE24P, VFSUE30N and VFSUE30P; N for natural gas, P for propane) is a vent-free gas log burner for see-through and peninsula fireplaces and fireboxes, in 18", 24" and 30" sizes. It needs a Rock Creek or Stone River multi-sided log set, ordered separately.

Intermittent pilot ignition lights it from the included thermostat remote, which also varies the flame; it runs on an AC adapter with battery backup. It can also be installed as a vented decorative appliance with the damper clamped open, using a non-thermostat remote.

Key Features

  • Multi-sided burner for see-through and peninsula fireplaces
  • 18", 24" and 30" sizes, up to 40,000 Btu/hr
  • Intermittent pilot with thermostat remote and variable flame, included
  • Uses Rock Creek refractory or Stone River ceramic fiber multi-sided logs
  • Lava rock and rock wool embers included
  • Oxygen depletion sensor shuts it off if fresh air runs low

What to Order With It

The burner ships with lava rock, rock wool embers, a damper clamp and anchor screws, plus the thermostat remote.

Log sets for the 18" Vista burner (one required, ordered separately):

Log sets for the 24" Vista burner (one required, ordered separately):

Log sets for the 30" Vista burner (one required, ordered separately):

Optional – Embers and hood:

Optional – Non-thermostat remote (required for vented use):

Specifications

Model numbers VFSUE18N, VFSUE18P, VFSUE24N, VFSUE24P, VFSUE30N, VFSUE30P
Sizes 18", 24" and 30" multi-sided burners
Type Unvented (vent-free) gas log burner, or vented decorative appliance
Input, maximum 18": 36,000; 24": 38,000; 30": 40,000 Btu/hr, natural gas and propane
Input, minimum 18": 25,000; 24": 26,500; 30": 28,000 Btu/hr
Control Intermittent pilot with thermostat remote and variable flame, included; AC adapter with battery backup
Safety Oxygen depletion sensor (pilot safety system) shuts the burner off if fresh air runs low
Fuel Natural gas or propane; field conversion not permitted
Minimum firebox See the minimum fireplace dimensions in the installation manual
Log set Required: Rock Creek (LSU-RR) or Stone River (LSU-SF) multi-sided set of the same size

Installation Requirements

  • Where it can go: in a solid-fuel-burning masonry or UL 127 factory-built fireplace, or a listed vent-free firebox; not in a factory-built fireplace whose instructions say it should not be used with unvented gas logs. Have the chimney and firebox cleaned first, and seal any fresh-air vents or ash doors in the firebox.
  • Firebox size: see the minimum fireplace dimensions in the installation manual. With glass doors, use the door frame opening as the front width; the doors must be fully open whenever the logs burn.
  • Room size: the room must be an unconfined space of at least 50 cubic feet per 1,000 Btu/hr of input of all gas appliances drawing air from it, or extra combustion and ventilation air must be provided as the National Fuel Gas Code describes. Vent-free heaters are for supplemental heat, not as a primary heat source.
  • Bedrooms and bathrooms: an unvented heater over 10,000 Btu/hr may not go in a bedroom or bathroom, so this burner cannot. Massachusetts prohibits unvented gas heaters in bedrooms and bathrooms.
  • Clearances: the sides of the fireplace opening at least 6" from any combustible wall; a ceiling at least 41" above the opening.
  • Mantel: non-combustible material must extend at least 12" above the opening, or 8" with the optional ELH1 hood. A combustible mantel must meet the mantel chart in the installation manual.
  • Vented use: the burner can be installed as a vented decorative appliance with the damper clamped open; thermostats may not be used in a vented installation, so the VFSUE needs a non-thermostat remote (R10815) for vented use.
  • Media: rock wool (glowing embers) goes on the front of the burner, never over the large burner ports; lava rock goes on the firebox floor only, never on the burner or logs. Use only Empire logs made for this burner, placed as the log set manual shows.
  • Fuel: order the model for your gas; field conversion is not permitted.
  • Installation: must be installed by a qualified installer per the installation manual and local codes, with the burner anchored to the firebox floor. In Massachusetts the installation must be done by a licensed plumber or gas fitter.

Downloads

Warranty

Empire limited warranty, from the warranty section of the installation manual:

  • All components, except remote controls, thermostats, accessories and replacement parts: 5 years parts and labor
  • Remote controls, thermostats, accessories and parts: 1 year parts

The warranty applies to the original purchaser. Full terms, including what is not covered, are in the warranty section of the installation manual.